It’s a bar bearing support equipped with a roller. It can be used in addition to the roller table. It should be suitably ballasted or fixed to the floor. Roller 550 mm wide, max load 750 Kg, H min 840 mm / H max 1.015 mm.
Code: C2

Roller table-machine connection on loading side.
Code: CRC

The band saw machine can be equipped of a blade and cutting cooling device. To improve the cutting quality and reduce pollution risk, moreover to avoid the risk of pools of cooling liquid on the floor (possible cause of accidental falls), we suggest to use the NB optional.
Code: NB1 Box-NB2 Box

Device for vertical clamping of the material, hydraulic cylinder and manual positioning. During the cutting cycle the vertical cylinder works together with the vice for the material clamping.
Code: DOTM

The closing pressure adjustment of the vice RPM1,decreasing from the standard machine max. pressure, is used for materials having thin thickness and consequently that can be easily deformed. It is not possible to reduce the pressure value adjusted by the hydraulic system pressure switch under the safety value of 6 bar.
Code: RPM1

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.
Code: SENS

Allows to read, by means of a digital display, the cutting angle with an accuracy to tenths of a degree. With the graduated plate placed the standard machines, this is not possible. It also allows a good view of reading in low light.
Code: VAT

Length stop on unloading side with hydraulic cylinder for the backing of the stroke reference during the cut. Available lengths  from 1 m to 6 m.
Code: FM..RI

Articulated striker. The machine may be equipped with a length stop for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RP roller tables.
Code: FM..RS