OPTIONAL BANDSAW MACHINES SEMIAUTOMATIC

The band saw machine can be equipped of a blade and cutting cooling device. To improve the cutting quality and reduce pollution risk, moreover to avoid the risk of pools of cooling liquid on the floor (possible cause of accidental falls), we suggest to use the NB optional.
Code: NB1 Box-NB2 Box

Device for vertical clamping of the material, hydraulic cylinder and manual positioning. During the cutting cycle the vertical cylinder works together with the vice for the material clamping.
Code: DOTM

The closing pressure adjustment of the vice RPM1,decreasing from the standard machine max. pressure, is used for materials having thin thickness and consequently that can be easily deformed. It is not possible to reduce the pressure value adjusted by the hydraulic system pressure switch under the safety value of 6 bar.
Code: RPM1

The SENS optional is assembled on the flywheel. In case the blade collapses due to an insufficient tension exerted by the stretcher or in case it goes stuck into the piece during the cut, the work cycle would immediately stop. In this way the SENS optional protects the motor wheel and the blade itself.
Code: SENS

Allows to read, by means of a digital display, the cutting angle with an accuracy to tenths of a degree. With the graduated plate placed the standard machines, this is not possible. It also allows a good view of reading in low light.
Code: VAT

This option allows a considerable reduction in working times: it speeds up the descent of the blade and decreases its lifting speed. On the head there is a fast approach device allowing the rapid approach of the blade when this is near the work piece to be cut. After cutting, the blade goes back only what is strictly necessary out of the piece and it is immediately ready for the next cut.
Code: TM

Blade tension reading cylinder with pressure gauge
Code: MT H27

The option LX facilitates the operator during the cutting phase: a luminous red line (laser light) is projected on the piece locked in the vice to exactly display where the blade will make the cut.
Code: LX

Additional supporting plate for the cut at 0°, useful in case of cut of short pieces.
Code: PAT 0°

Roller for the material support with diameter = 50mm. Cut at max 40°, excludes the standard measuring rod
Code: SR D