• Fully enclosed machine, with easy access for blade replacement and ordinary maintenance.
• Possibility to load material directly on the carriage by overhead crane.
• Designed for lifting with forklift.
• Carriage with 500mm stroke, controlled by ball screw and encoder.
• Carriage retracts at the end of the cut to prevent blade damage. Retraction can be set via software
• Carriage vice with retractable fixed jaw, allowing the cutting of uneven bars.
• Non-feedable bar end: 75mm.
• Carriage vice and cutting vice with full stroke cylinders.
• Minimum cutting length: 8mm.
• Vertical vices optional (MV-A). Minimum cutting length: 25 mm (no reduction in cutting capacity)
• Movable blade-guide arm with automatic positioning.
• Head descent on double column on linear guides.
• Gear reduction unit with hardened and ground alloy steel gears, lubricated withlong-life oil.
• Hydraulic blade tension.
• Blade rotation control sensor.
• Mechanical device for material presence detection on feeding carriage.
• Swarf screw extractor supplied as standard, can be installed on either the right or left side of the machine and can be programmed via software.
• 180l coolant tank with double water pump and six coolant outlets.
• Cutting zone completely clear for optimal swarf discharge.
• Cutting area LED light.
• Possibility to perform different interrupted cuts within the same cutting cycle.
• Full protection against overvoltage and short circuits. Protection level IP 55.
• Line voltage: 400V/50Hz/3Ph standard (230V/50Hz/3Ph - 220V/60Hz/3Ph - 440V/60Hz/3Ph available).
• Machine colours: yellow RAL 1018 and grey RAL 7016.

SOFTWARE FEATURES

• 10” touchscreen control panel with innovative user interface.
• Automaticadjustment of cutting parameters and rapid head descent based on material andworkpiece size.
• Linux-basedsystem, virus-free
• Multilanguagesoftware.
• 19 preloadedmaterial families with the possibility to add custom materials.
• Savingcapacity for up to 90 programs
• Daily,weekly, partial and total statistics.
• Blade cutscounter.
• Cuttinglength, number of pieces and interrupted cuts can be modified in real time,even during operation.
• Ideal bladetoothing and adaptive cutting speed based on actual cut.
• Fast approachwith laser.
• Remote assistancethrough the optional MT-A module