AUTOMATIC DOUBLECOLUMN BAND SAW MACHINE WITH H41 BLADE TO CUT AT 0° WITH DIMENSIONS UP TO 460x460 mm.
- Fully enclosed machine, with easy access for blade replacement and ordinary maintenance.
- Possibility to load material directly on the carriage by overhead crane.
- Designed for lifting with forklift.
- Gear reduction unit with hardened and ground alloy steel gears, lubricated withlong-life oil.
- Carriage with weight-bearing structure with 500mm stroke, controlled by ball screw and encoder.
- Carriage retracts at the end of the cut to prevent blade damage. Retraction can be set via software
- Carriage vice with retractable fixed jaw, allowing the cutting of uneven bars.
- Non-feedable bar end: 75mm. (MSR optional to reduce it to 20mm).
- Carriage vice and cutting vice with full stroke cylinders.
- Minimum cutting length: 8mm.
- Vertical vices optional (MV-A). Minimum cutting length: 25 mm (no reduction in cutting capacity)
- Movable blade-guide arm with automatic positioning.
- Head descent on double column on linear guides.
- Hydraulic blade tension.
- Blade rotation control sensor.
- Mechanical device for material presence detection on feeding carriage.
- Swarf screw extractor supplied as standard, can be installed on either the right or left side of the machine and can be programmed via software.
- 180l coolant tank with double water pump and six coolant outlets.
- Cutting zone completely clear for optimal swarf discharge.
- Cutting area LED light.
- Blade inclination selectable when ordering:
Athena 41A: blade at 0°
Athena 41A I: blade inclined by 1,5°(specific for rectangular and square sections)
- Possibility to perform different interrupted cuts within the same cutting cycle.
- Full protection against overvoltage and short circuits. Protection level IP 55.
- Line voltage:400V/50Hz/3Ph standard (230V/50Hz/3Ph - 220V/60Hz/3Ph - 440V/60Hz/3Ph available).
- Machine colours: yellow RAL 1018 and grey RAL 7016.
SOFTWARE AND TOUCH SCREEN FEATURES:
- 10” touch screen control panel with innovative user interface.
- Linux-based system, virus-free
- Multilanguage software.
- 19 preloaded material families with the possibility to add custom materials.
- Saving capacity for up to 90 programs
- Ideal blade toothing and adaptive cutting speed based on actual cut.
- Automatic adjustment of cutting parameters and rapid head descent based on material and workpiece size.
- Cutting length, number of pieces and interrupted cuts can be modified in real time, even during operation.
- Daily, weekly, partial and total statistics.
- Blade cuts counter.
- Swarf conveyor programmable via software.
- Remote assistance through the optional MT-A module.