ROLLER-TABLES BANDSAW MACHINES MANUAL

Home / Roller-tables Bandsaw machines Manual
C2 - Frame

It’s a bar bearing support equipped with a roller. It can be used in addition to the roller table. It should be suitably ballasted or fixed to the floor. Roller 550 mm wide, max load 750 Kg, H min 840 mm / H max 1.015 mm.
Code: C2

CRC - Loading side connection

Roller table-machine connection on loading side.
Code: CRC

CRS - Connection in unloading side

The unloading side connection between machine and roller table.

Code: CRS

FM..RSP - Heavy length stops

The machine may be equipped with a measure shaft for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RP roller tables.
Code: FM..RSP

FM..RS - Length stop

Articulated striker. The machine may be equipped with a length stop for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RP roller tables.
Code: FM..RS

RFP2 A - Roller table

2 m long roller table  and max load 1000 Kg/m (h min 725 mm / h max 780 mm).
Code: RFP2 A

RP1G-RP2G - Roller tables

Roller table available in units 1 meter long each with idle rollers 400 mm wide and loading capacity of 300 Kg/m. Maximum height h=1000mm, minimal height h=910mm.
Code: RP1G-RP2G

RRS - Unloading side pull-out roller surface

Unloading side connection between machine and roller table.
Code: RRS

RM - Motorized roller

Our motorized roller can be joined to all models of FMB band saws so that any movement is avoided during the cut. Its moving is electrical and its lifting power is 1.500 Kg.

Code: RM - Rullo motorizzato

CREC -Loading side connection

The loading side connection between machine and roller table specific for RE1G–RE2G roller tables.
Code: CREC

Cerchi una segatrice specifica per il taglio di materiali speciali?
Contattaci, il personale del nostro staff ti risponderà nel più breve tempo possibile.