ROLLER-TABLES MERCURY+G

Home / Bandsaw machines Manual / Mercury+G / Roller-tables
C2 - Frame

It’s a bar bearing support equipped with a roller. It can be used in addition to the roller table. It should be suitably ballasted or fixed to the floor. Roller 550 mm wide, max load 750 Kg, H min 840 mm / H max 1.015 mm.

Code: C2 Layout
CRC - Loading side connection

Roller table-machine connection on loading side.

Code: CRC Layout
CRS - Connection in unloading side

The unloading side connection between machine and roller table.

Code: CRS Layout
FM..RS - Length stop

Articulated striker. The machine may be equipped with a length stop for 1 to 6 meters (3.3 to 19.7 ft) measure stops to be installed on the RP roller tables.

Code: FM..RS 75
RM - Motorized roller

Our motorized roller can be joined to all models of FMB band saws so that any movement is avoided during the cut. Its moving is electrical and its lifting power is 1.500 Kg.

Code: RM - Rullo motorizzato Layout
RMN

Digital measure reading system with manual striker positioning including idle roller tables RE2G + RE1G + connections CRES and RRS (H min= 910mm / H max= 1000mm).

Code: RMN 286
RP1G-RP2G - Roller tables

Roller table available in units 1 meter long each with idle rollers 400 mm wide and loading capacity of 300 Kg/m. Maximum height h=1000mm, minimal height h=910mm.

Code: RP1G-RP2G Layout
RRS - Unloading side pull-out roller surface

Unloading side connection between machine and roller table.

Code: RRS Layout
SMN

Digital measure reading system, with manual positionning of the strike, without roller tables.

Code: SMN 314